Switzerland abundant precision tell you precision components processing requirements

For precision parts, processing is very strict, feed processing operations, a knife, etc. Have specific requirements for size, accuracy requirements, such as how many microns of plus or minus 1 mm, if the wrong size too much will become a waste, at this moment is the equivalent of reprocessed, time-consuming, and sometimes even make the whole processing scrap material, this will result in an increase in the cost, at the same time, the parts are certainly is unusable. For precision parts processing mainly size requirements, such as the cylinder diameter is how many, have strict requirements, plus or minus error in the range of specified requirements is the qualified part, or are unqualified parts; Three high also have specific strict requirements, plus or minus error also has a regulation, such as an embedded type cylinder ( Get the most basic components, for example) , if the diameter is too large, more than the range of allowable error, will cause, not go in, if the actual diameter is too small, more than the negative value of allowable error threshold, will cause is too loose, inserted in unstable problem. These are all substandard products, or cylindrical length is too long or too short, beyond the range of allowable error, are unqualified products, is will be obsolete, or reprocessed, this will inevitably result in an increase in the cost. The requirements of the precision parts processing is the size of the main problems, must be in strict accordance with the additional drawings for processing, processing of actual size won't theory and drawing the same size, but, as long as the dimensions in the range of allowable error are qualified parts, so the precision parts processing requirement is in strict accordance with the theoretical size for processing. Followed by the advanced precision parts processing equipment and testing equipment, advanced processing equipment makes more simple when processing precision parts, precision is higher, the effect is better. Testing equipment that can detect didn't meet the requirements of parts, let all sent to the customer's products truly meet the requirements.
NINGBO HENRY PARTS INC. have now decided to extend our company in other countries.
Reach us at HENRY PARTS. We'll always try to give you the BEST deal on . If we can't, we'll at least give you some hel pful advice. Please use our experience!
In a nutshell, is actually an ultimate solution for mechanical parts manufacturer and underestimating its value cost you higher than anything else. So grab it before you miss the boat.
There are so many factors that businesses have to weigh when producing SERVICE, and we are not going to pretend to grasp all of them.